F1000 LFP utilizes high quality UL certified automotive LiFePO4 battery, it can retain 80% of its original capacity at 3500 complete charge cycles.

Please note that the AC output port can only charge or power devices that operate at less than 1500W(120V). DC output port can only charge or power that operate at less than 12V-10A.

F1000 LFP supports UPS function with an automatic switchover time of 8~20ms.

To estimate the operation time of the F1000 LFP, consider the load you're applying: Operation time = Battery Capacity (Wh) x DoD x n ÷ (Load Power + F1000 LFP Self-con-sumption) Note: DoD is the depth of discharge. n is the conversion efficiency of the inverter, which is typically over 93% for the F1000 LFP. The self-consumption power of the F1000 LFP is approximately 11W. Example Calculation (40W Load) = 1004Wh x 95% x 93% ÷ (40W + 11W) ≈ 17 hours. Please keep in mind that the estimated operation time provided is for referencepurposes and may vary based on actual usage conditions. Factors such as lowtemperature and excessive loads can sianificantly affect the battery capacity, leading toa reduction in the average operation time.

Yes, It can be charged and discharged at the same time. Under the non-UPS state, if uninterrupted use is required, the average power of charging must be greater than the average power of electricity, otherwise the battery will eventually run out and shut down.

Yes, there is one independent built-in MPPT controller; “XT60”port supports 11~60V (Max 600W) PV input.

Pay attention to the ponit that the product is without waterproof function and prevent water getting into it. Pay attention to ventilation and heat dissipation when using, and keep good ventilation at the air inlet and outlet of the product. Do not use the product in special occasions (under the mine, gas station, etc.)