The solar input supports an 11-60V solar charger with an XT-60 connector. If you use an 11-15V solar charger, the current supports 10A max. When you use a 15-60V solar charger, the current supports 27A max (firmware 2.1.1+).

If the power station is stored at a low capacity for a long time, lithium batteries will self-consume power which may lead to a quick discharge. This leads to poor conductivity and a reduced battery lifespan, resulting in poor battery performance.

To store your portable power station, make sure you have: 1. Turned off all outputs. 2. Store it in a cool and dry place. 3. Check the battery capacity each week. If it's below 30%, fully charge. 4. Charge the power station to 100% every 3 months.

No, when Anker SOLIX F3800 is recharging with AC power, you can only use its 120V UPS outlet to charge other devices.

Double-press the 240V power switch to activate EV mode charging, then you can recharge your EV.

The maximum open-circuit voltage of each solar input port is 60V. If you want to chain the solar panels in series, the total open-circuit voltage must not exceed 60V.

The output power of the solar charger is not only related to the weather, but also the area of direct sunlight. For maximum sunlight and larger output power, adjust the position and angle of the solar charger.

Anker SOLIX PS400 Solar Panel can charge portable power stations with a maximum voltage of up to 60V and has an MC4 input port. We recommend pairing the solar panels with SOLIX F2000 Portable Power Station

PS400 Solar Panel has an IP67 certification. It is waterproof and can be used in wet weather. However, the MC4 ports must be covered with the rubber plug before being exposed to rain or water.

The solar panel has an MC4 output port.

The optimum operating voltage is 48V, and the optimum operating current is 8.33A.